Products - Tools And Equipment

TP-TACT Tester & Programmer TP-TACT Tester & Programmer
The TP-TACT device is intended for testing and programming the operation of a wide range of turbocharger operation controllers.

With TP-TACT it is possible to perform the following tests:
- Test of electronic turbocharger controllers with Westgate
- Test of electronic turbocharger actuators with variable geometry (VTG, VNT)
- DC actuator motor test
- Westgate position or variable geometry sensor test
- Test of solenoids that control the pressure of the turbocharger in pneumatic systems
VNTD 750 Flow Bunch VNTD 750 Flow Bunch
VNTD 750 Tester is a unique, dynamic VNT calibration and flow bench dedicated to manufacturers of complete turbochargers, manufacturers of nozzle rings, as well for Turbocharger repair service shops. The enormous capabilities of this machine allow for calibrating turbochargers with wastegates, pressure actuators, vacuum actuators and electronically controlled VNT. Thanks to clamping solution of a turbocharger on a machine, the cycle time for calibrating one part is very short.

Also,
- You can perform leak test and calibration of pneumatic actuators.
- You can check the moment of the correct actuator movement, in order to perform correct regulation of VNT.
- You can create Your own database.
- You can perform test for car, van and truck turbochargers, thanks to 750Kg/h flow possibility of the VNTD 750
DPF CLEANER DPF CLEANER DPF CLEANER
DPF Washing Machine (Diesel Particle Filter)

DPF Washing Machine or FAP filter is used when it is impossible to perform DPF regeneration on the vehicle, with the help of a diagnostic device. DPF cleaning is a high quality device, which is composed of very high quality and complex systems, so that it can perform testing before and after washing DPF filters.

Functions:
- Touchscreen display
- Clogging testing before and after the washing process
- Cleaning process (rinsing and drying)
- Hot air drying (hair dryer 3000l / min + 16kw heater) achieves the best results at 10 minutes and 120 ° C
- Printing of results (workshop name, pressure before and after cleaning, ...)
- Multilingual software
- Manual control of functional elements (valves, pumps, hair dryers, heaters)
- Water temperature setting (not more than 55 ° C)
- Adjusting the air temperature for hot drying (not more than 150 ° C)
- Adjusting the air pressure during the cleaning process
- Setting the cleaning time